By the time you see a stain or hear dripping, a burst pipe has often already been running for a while inside the wall.
Our Lennox, SD Burst Pipe Water Damage crews start with locating the shutoff valve and confirming water pressure has actually stopped.
Stopping the water source is priority one before any extraction begins.
We use pressure testing and moisture tracing to locate exactly where a supply line failed inside the wall.
Drywall and insulation come out only where moisture readings confirm saturation, not the entire wall.
Handoff to a licensed plumber is built into our burst pipe process, not left for you to arrange separately.
A burst pipe call has a specific sequence — find the source, stop it, open only what's necessary, and coordinate repair — here's how our Lennox, SD crews run it.
We locate and confirm the shutoff valve is closed the moment the crew arrives.
We locate the failure point before opening any drywall, avoiding guesswork demolition.
Water trapped inside the wall cavity gets extracted using specialized tools designed for tight spaces.
Targeted removal limits the repair scope to what's actually necessary.
Drying continues until wall cavity moisture readings hit dry standard.
We coordinate scheduling with a licensed plumber for the pipe repair itself.
Tell our Lennox, SD dispatcher if the water source is still running so we can advise on shutoff immediately.
A technician heads to your Lennox address with wall-cavity extraction tools loaded.
You'll see the scope and cost once the failure point is confirmed.
The job isn't done until both drying and repair coordination are confirmed.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
We can confirm which you're dealing with during the initial assessment.
No, we remove drywall only at the confirmed wet line based on moisture readings.
We can refer a plumber or work alongside yours to keep the timeline aligned.
If you can safely reach it, shut off the water at the main or local valve to stop the flow.
Wall cavity drying typically takes 3-5 days depending on how much insulation and framing was affected.
Lennox sits within our core burst pipe response zone.
Speak directly with our burst pipe response team.
Call +1-844-833-1325